V60 vs Chemex: Which Pour Over Should You Buy?

The V60 uses a steep 60-degree cone with a single large hole, forcing you to control extraction through pour technique. The Chemex uses thicker filters and a gentler cone, producing a cleaner, tea-like cup with almost no fines.

Who each is for

Reach for the V60 when you want to dial in a single cup fast, express bright single origins, and enjoy the ritual of pouring. Reach for the Chemex when you want to brew for two or three people, love an ultra-clean body, and prefer forgiving technique.

Which I keep on the counter

Both, honestly. The V60 gets the weekday cup because it's quick and expressive. The Chemex comes out on weekends when I want to share a batch and let the coffee sit gracefully on the table.

Going deeper

Most guides stop at the recipe. This one goes further — into the choices behind the numbers, the small adjustments that separate a decent cup from a great one.

Reading the bed after brewing

The spent coffee bed tells you exactly what happened. A flat, even bed with a small dome in the center means uniform extraction. A crater or channel means water bypassed some of the grounds — usually caused by an aggressive pour or an uneven initial distribution. High walls of coffee stuck to the paper mean you didn't rinse the sides down enough. Take ten seconds to look before you rinse the dripper.

Dialing in grind size

Grind is the single biggest lever you have. Too coarse and the brew runs fast, tastes thin, and finishes sour. Too fine and it stalls, over-extracts, and turns bitter. Start medium-fine — roughly the texture of table salt — and adjust in small steps. If your total brew time lands under 2:45, tighten the grind two clicks. Over 3:45, open it up two clicks. Never change grind and ratio in the same session; you'll never know which variable moved the cup.

Pouring technique that actually matters

Pour in slow concentric circles from the center outward, then back. Keep the kettle spout two to three inches above the bed so the water enters gently instead of drilling a channel. Avoid pouring directly on the paper — grounds stuck to the wall don't extract. Pulse pouring (multiple small pours) gives you more control than a single continuous pour, especially on lighter roasts that need agitation to open up.

Water quality and temperature

Coffee is 98 percent water, so bad water guarantees a bad cup. Aim for 150 ppm total dissolved solids with a balanced calcium-to-magnesium ratio. Third Wave Water and Lotus Water Drops both make this trivial. Brew temperature belongs between 195 and 205 degrees Fahrenheit — hotter for dense light roasts, cooler for darker ones. A thermometer or a temperature-controlled kettle removes the guesswork entirely.

Common mistakes to avoid

The fastest way to improve is to stop doing the wrong thing. In order of frequency: using stale coffee, skipping the scale, running the water too cool, and changing multiple variables at once. Fix those four and you're brewing better than 90 percent of home setups.

Final thoughts

Coffee at this level rewards attention, not spending. A modest setup used consistently beats an expensive setup used carelessly, every time. Give any technique two weeks of daily practice before deciding whether it works for you — palate takes longer to train than muscle memory.